Multi-tech-systems MT5634ZPX Bedienungsanleitung PDF herunterladen (Seite 82)

MT5634ZPX

Owner’s Manual

Australian and New Zealand Modem

Warning Notice

Australian Modem Warning Notice

Modems connected to the Australian telecommunications

network must have a valid AUSTEL permit. This modem has

been specifically configured to ensure compliance with AUSTEL

Standards. The following commands can affect compliance and

must not be set outside the acceptable range.

Modem Commands:

Command Default Permissible Range

A: - Do not use

ATB B0 Do not change

AT&G &G2 Do not change

AT&P &P1 Do not change

ATSn see table below

S-Register Default Permissible Range

S6 4 2 - 5

Call Attempts/Retries:

Applications software shall be configured so that no more than 3

attempts are made to establish a connection to a given number

(Note: if the modem can detect service tones, up to 10 attempts

can be made). There must be at least 2 seconds between call

attempts. If the call sequence is unsuccessful, there shall be a

delay of at least 30 minutes before attempting to call the number

again.

Failure to set the modem, and any communications software

used with the modem, to the values shown above will result in

the modem being operated in a non-compliant manner.

Consequently, there would be no permit in force for this

equipment, and the Telecommunications Act 1991 prescribes a

penalty of $12,000 for the connection of non-permitted

equipment. re to set the modem, and any communications

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 88

Keine Kommentare

Multi-tech-systems MT5634ZPX Bedienungsanleitung Seite 82